How to Add Quilt Binding and Stitch it Down

I’m sharing the way “I” do quilt binding. Like everything in quilting there are MANY ways. This is the way “I” do it ! !

Cut your strip 2 ½” inches wide and long enough to go

all the around your quilt PLUS 6-8 Inches

More is ALWAYS better with this

The Quilt Ladies NOW on Kindle and NOOK

Cut enough strips to go around the outside edge of your
quilt. Sew all strips together with a 45-degree angle.

How to make Quilt Binding Tutorial and How to Hand Stitch the Bind

Sew and Trim to ¼ inch seam allowance
Open and Press and trim any ends. Do this
to make all binding needed.

The Quilt Ladies NOW on Kindle and NOOK

ALWAYS check YOUR BOBBIN THREAD, make sure you have enough to make it all the way around the quilt. NOTHING worse than to stop and fill or change a bobbin!

This is where “I” do it a bit different, I just can’t get the seam right using the fold the corner way, I do a straight seam here as shown

Start sewing about 5-6 inches from your binding end,

Sew the binding with a ¼ inch seam allowance.

I mark with a pin on each cornerSew the binding with a ¼ inch seam allowance. Stop ¼ from
the edge. Back stitch a few stitches.Fold the binding back. Fold binding back down on to the Quilt. Match up edges. A diagonal fold will form between the
layers and a straight fold on top. Do corners one at a timeDo this on all four cornersStop sewing about 4-5 inches from the first end. Pin well, fold over and match the endsPressOpen up and mark your SEWING line On both sidesThis is your SEWING line, Sew and trim seam.Continue sewing the binding to the quilt. The right side of the quiltYou will need to trim your batting, I like to trim mine about an 1/8 of an inch from the binding edge